IOS version 12.4.25d (Mainline) File name:.
This Image was tested with Gns3 1.1 and i hope this will also work fine with the latest GNS3 version as well. All network devices between the attacker and the affected device must support an MTU of 1800 bytes or greater. If the router does not receive new SNMP Set requests within 5 seconds (the default value), the candidate configuration is committed and the Junos OS XML. Following are the details and recommended setting of Gns3 3745 IOS image for your GNS3 setup. To exploit this vulnerability, the attacker may need access to the trusted network where the affected device is in order to send specific packets to be processed by the device. A successful exploit could allow the attacker to cause the device to reload. Cisco Catalyst 9200L and 9400 Series Switches running IOS-XE 16.9, Version 1.0 Report Number: CCEVS-VR-VID10972-2019 Dated: 07/24/19 Version: 1. An attacker could exploit this vulnerability by sending traffic to an affected device that has a maximum transmission unit (MTU) of 1800 bytes or greater. NAME: '3rd generation four port FXS DID voice interface ubSlot 2', DESCR: '3rd generation four port FXS DID voi ' NAME: '3rd generation four port FXS DID voice interface ubSlot 3', DESCR: '3rd generation four port FXS DID voi ' -If you buy more than one item, each item must be paid SEPARATELY. This vulnerability is due to buffer exhaustion that occurs while traffic on a configured IPsec tunnel is being processed.
A vulnerability in the IPSec decryption routine of Cisco IOS XE Software could allow an unauthenticated, remote attacker to cause an affected device to reload, resulting in a denial of service (DoS) condition.